Trouble Recovery
79
EMU29463
Replacing fuse
If the fuse has blown on an electric start
model, open the fuse holder and replace the
fuse with a new one of the proper amperage.
WARNING
EWM00631
Substituting an incorrect fuse or a piece
of wire could allow excessive current
flow. This could cause electric system
damage and a fire hazard.
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU29524
Power trim and tilt will not operate
If the engine cannot be tilted up or down with
the power trim and tilt because of a dis-
charged battery or a failure with the power
trim and tilt unit, the engine can be tilted
manually.
1.
Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
2.
Put the engine in the desired position,
then tighten the manual valve screw by
turning it clockwise.
EMU29533
Starter will not operate
If the starter mechanism does not operate
(the engine cannot be cranked with the start-
er), the engine can be started with an emer-
gency starter rope.
WARNING
EWM01022
●
Use this procedure only in an emergen-
cy to return to the nearest port for re-
pairs.
●
When the emergency starter rope is
used to start the engine, the start-in-
gear protection device does not oper-
ate. Make sure the remote control lever
is in neutral. Otherwise the boat could
unexpectedly start to move, which
could result in an accident.
●
Attach the engine shut-off cord to a se-
cure place on your clothing, or your
arm or leg while operating the boat.
●
Do not attach the cord to clothing that
1. Fuse holder
2. Fuse (20 A, 30 A)
1
2
ZMU03919
1. Manual valve screw
ZMU03464
1
