94
Chapter 9—Aux Sends
03D—Owner’s Manual
Aux Send Stereo Pairs
Aux sends 1/2 and aux sends 3/4 can be configured as stereo pairs. Aux send stereo pairs
are configured on the Pair page. See Stereo Pairs on page 114 for more information.
When aux sends are paired, the following aux send master parameters are linked: EQ,
faders, dynamics processors, [ON] buttons, and monitor. Since these parameters are
linked, you can adjust the master controls of either aux send in a stereo pair. In addition,
aux send pan controls are activated on the input channels, stereo input channel, and
effects returns. The aux send pan controls are available on the AUX Pan pages. Two
AUX Pan pages are available: one for aux pair 1/2 and one for aux pair 3/4.
If your select an AUX Pan page and the respective aux sends are not configured as a ste-
reo pair, an AUX Pan page like the one shown below appears.
When aux sends are configured as a stereo pair (Stereo Pairs on page 114), an AUX Pan
page like the one shown below appears.
1. Use the [AUX 1] or [AUX 2] button to locate the AUX 1–2 Pan page, or
the [AUX 3] or [AUX 4] button to locate the AUX 3–4 Pan page.
2. Use the [SEL] and [MIXING LAYER] buttons to select a channel. See Mix-
ing Layer on page 31 for more information.
3. Use the cursor buttons to select the pan controls and the PARAMETER
wheel to set them.
If you are using a mouse, position the mouse cursor over a pan control, press and hold
the left mouse button, and then drag the mouse.
Input channels 1 to 24 use a single pan control to pan signals between the
paired aux buses.
The stereo input channel and effects returns have two pan controls: one
for the left signal and one for the right. These pan controls can be used to
adjust the width of stereo signals.
