Yamaha 02R, Owner'S Manual, Page: 298 / 354

188 Installing Options
Digital Recording Console 02R User’s Guide
Wordclock Selection
1. Power on your DA-88 modular digital multitrack recorder and
then the 02R.
It is always important to observe the correct order for powering up
equipment in a studio. Start with the DA-88 and mastering recorders
and the signal processors, then the 02R, and finally the monitoring
amplifiers and other downstream gear.
2. Press the [DIGITAL I/O] button until the “Word Clock Select”
screen appears.
If the card was installed properly, the system software should correctly
identify it in the appropriate slot. The TDFI-1 digital I/O card
(CD8-TDII) can be installed in any slot. You should install the first two
cards in SLOT1 and SLOT2 in order to access the direct out lines.
3. Use the CURSOR buttons to select the wordclock source.
Use the CURSOR buttons to select the W.CLK IN box and press the
[ENTER] button.
4. When you select the wordclock source, the appropriate icon
should be inverted in reverse video.
See “Word Clock Select” on page 154 of the User’s Guide for further
details.
Note:
If the W.CLK IN box is not showing a proper wordclock input (no
discrepancy between the input and selected wordclock frequencies), check the
BNC cable between the WORD SYNC OUT connector on the DA-88 and the
WORD CLOCK IN connector on the 02R.Check that the DA-88 is powered
on.