Yamaha 02R, Owner'S Manual

Page: 56 / 354

Secondary Recording Tutorial 47
Digital Recording Console 02R Getting Started Guide
2. Select MIC/LINE 1 using the [SEL] buttons or the CURSOR buttons.
Turn the auxiliary send on by pressing the [AUX 7] button and then the
[ON] button in the AUX group of the SELECTED CHANNEL controls.
3. Press the [ENTER] button to change the auxiliary send from pre to
post fader.
Sends to the effects are usually post fader. This means the the signal level
feed into the effects processor to follow the “dry” channel level.
4. Adjust the fader for MIC/LINE 1 until the desired signal level is
obtained.
Adjusting the Effect Return
The effect return channel is similar to one of the input channels except that
it has no analog component, and therefore no gain or input pad need to be
applied. Otherwise the steps are similar to those starting with “Setting the
GAIN” on page 21 of the
Getting Started Guide .
The easiest way of applying all the required adjustments is to select the
View display function. This allows you to see all the parameters of the
channel on one screen, while you can still use the dedicated buttons and
controls of the SELECTED CHANNEL group.
1. Press the [VIEW] button and press the [SEL] button for EFF 1 RTN.
The VIEW display function for the effect return channel EFF 1 RTN
appears:
2. If the sound is distorted or the level is constantly going up to CLIP,
use the CURSOR buttons to select the
∅
/ATT icon. Adjust the level
with the encoder wheel.
VIEW