182
Groups and Pairs
02R User’s Guide
Grouping Faders
The 02R allows you to group the faders for multiple fader control using
only one fader. This makes it easy to control several faders simultaneously.
The input channel and the tape and effect returns can be grouped. There
are four groups available: A, B, C, and D.
Shown below is the GROUP 1/2 page—Fader Group. You can group the
input channels—MIC/LINE 1 through 16 and LINE 17/18 through
23/24—and the tape and effect returns—TAPE 1 through 16, EFF1 and
EFF2:
The faders are listed in two main rows with the four group icons below
each channel number.
On the right side of the page are the “Enable” group select icons. You can
adjust the level balance within a group by turning the group on or off by
selecting the corresponding icon (a group is ON when its icon is
highlighted) and pressing the [ENTER] button. The LEDs inset in the [SEL]
buttons of the faders in the group will flash and they will be ungrouped
temporarily, allowing you to adjust the individual fader levels.
If you try to operate multiple faders, the first fader you select will have
priority. It is possible to upset the relative positions of the faders if you
attempt to operate more than one at a time.
Note:
A fader can only be assigned to one group. If you attempt to assign a fader
to more than one group, the message “Duplicate Grouping!” appears
1.
Use the [GROUP] button
to locate the GROUP 1/2
page.
2.
Use the CURSOR buttons
to select from group A
through D.
3.
Use the [SEL] buttons to
add or remove faders to
and from the selected
group.
Another method is to use
the CURSOR buttons to
select the faders and
press the [ENTER] button.
4.
Select a “Enable” group
icon and turn it on or off
by pressing the [ENTER]
button.
When a group is off, the
LEDs of the faders flash.
The individual levels
can be adjusted.
Note:
Stereo-pair channels
are added or removed
together.
GROUP
