01X Owner’s Manual
Overview of the 01X
29
Before Using
Basics Section
Appendix
Getting Started
Reference
Stereo input channels 1/2
These are stereo input channels used mainly for inputting
the return signal from internal effects 1/2. However, the
input signal assignment can be changed in the input patch
section, allowing these to be used as additional input chan-
nels.
The level (return level) of the stereo input channels can be
controlled by using the channel faders 7 (for Effect 1) and
8 (for Effect 2) when [MASTER] layer in the MIXER/
LAYER is seleced in Internal mode.
●
Differences from input channels
• Stereo
• No dynamics processor
• No direct output
• When using an internal effect via the Aux Send, do NOT turn up
the send level to the corresponding AUX bus for the channel to
which the effect return signal is routed. Doing so will result in
loud feedback, and may damage your equipment. For example,
when the 01X is in the default condition, AUX 3 is routed to the
input of internal effect 1, and the L/R signals of the ST IN chan-
nel 1 are routed to the output. If you turn up the send level of ST
IN channel 1 to AUX 3, a feedback loop is created.
• Since stereo input channels 1/2 are stereo, adjacent odd-numbered/
even-numbered signals will be assigned to them when MIC/LINE
inputs are selected as the input signals. Also, if DIGITAL STEREO IN
is selected, both L and R signals will be assigned.
Digital cascade connection
The input signal from the rear panel DIGITAL STEREO
IN connector can be cascade-connected directly to the ste-
reo bus, instead of being routed through the input patch
section and patched to an input channel. This is convenient
when you want to link an external digital mixer or similar
device with the mixer section of the 01X. (Refer to the
“Digital In Stereo Bus Cascade” on page 93.)
Oscillator
The 01X contains an oscillator that allows you to select
either sine wave (100Hz, 1kHz, 10kHz) or white noise.
The oscillator signal can be sent to rec bus, AUX buses 1
through 4, or the stereo bus. (Refer to the “Oscillator” on
page 93.)
ST IN 1(...2)
RECBUS (BUS) L
RECBUS (BUS) R
STEREO (STEREO BUS) L
STEREO (STEREO BUS) R
AUX 1
AUX 2
AUX 3 (FX1)
AUX 4 (FX2)
PAN
PAN
Stereo in X 2
(96kHz/88.2kHz: X 1)
4BAND EQ
4BAND EQ
ATT
ON
INPUT
SELECT (INPUT PATCH)
ATT
METER
METER
ON
LEVEL
AUX
PRE/POST
RECBUS (BUS) L
RECBUS (BUS) R
STEREO (STEREO BUS) L
STEREO (STEREO BUS) R
AUX 1
AUX 2
AUX 3 (FX1)
AUX 4 (FX2)
OSCILLATOR
LEVEL
ON
