Forks, Adjust
NOTE:
During the adjustment of the forks, the heel of the
forks should not be touching the ground.
The forks are connected to the carriage by hooks and lock
pins. See
and
. The lock pins are
installed through the top fork hooks and fit into slots in the
top carriage bar. If pin does not remain engaged in carriage
slot, replace with new pin. Adjust the forks as far apart as
possible for maximum support of the load. Hook forks will
slide along the carriage bars to adjust for the load to be lif-
ted. Raise the lock pin in each fork to slide the fork on the
carriage bar. Make sure the lock pin is engaged in the car-
riage bar to lock the fork in position after the width adjust-
ment is made.
Maintenance
158
Summary of Contents for VERACITOR GCC030VX
Page 24: ...Figure 6 Display Switch Cluster Right Side Display Inputs Model Description 22...
Page 40: ...Figure 8 Operator Controls Sheet 2 of 2 Model Description 38...
Page 83: ...Figure 13 Seat Adjustment Full Suspension Operating Procedures 81...
Page 172: ...Figure 43 LPG Tank and Bracket Maintenance 170...
