23
©
2019
Columbus McKinnon Industrial Products GmbH
Do not pull the rope over edges.
Do not tie knots in the rope or extend or shorten it by using rope clamps, screws or similar. Ropes must not be repaired.
The loose end of the rope must not be used for attaching loads.
Removal of the safety clamp from the load hook is prohibited.
The wire rope should never be fully uncoiled during operation. At least 2.5 windings must always remain on the drum.
The load must not be moved into areas which are not visible to the operator. If necessary, he must seek help.
Any modification of the lifting device is prohibited. A unit modified without consulting the manufacturer must not be used.
An optionally available rope guide should be used only if the rope drum is grooved and the wire rope has a maximum length so that,
when fully coiled on the drum, it fills up only the first position.
Never attach the load to the tip of the hook. The load must always be seated in the saddle of the hook. This also applies to the
suspension hook.
Turning of loads under normal operating conditions is not allowed. If loads must be turned in normal operation, an anti-twist swivel must
be used or the manufacturer must be consulted.
Do not throw the hoist or trolley down. Always place it properly on the ground.
Never reach into moving parts.
Only one load lifting attachment may be suspended in the load hook of the hoist.
The unit must not be operated in potentially explosive atmospheres.
A
SSEMBLY
Assembly and maintenance of the device is to be entrusted only to persons who are trained in the field in question and have been
commissioned by the owner to assemble and service the device.
These persons must know the common accident prevention rules, e.g. "Winches, lifting and hoisting devices (DGUV Vorschrift 54)",
"Cranes – power driven winches (EN14492-1)" etc., and must be appropriately trained. They should also be familiar with the operating
and installation instructions drafted by the manufacturer.
NOTE: If the unit is operated in the open, it must be appropriately protected against adverse weather conditions (e.g. by roofing).
ATTENTION: If the device is to be used in a construction lift, the appropriate specifications and directives must be observed.
Inspection Before Assembly
Check for transport damage
Check for completeness
• Check the wire rope or ropes for diameters matching the used electric rope winch.
• Check that the rated capacity data on the load hook in the used rope and device match.
