Yale 524150797, Maintenance Manual

Page: 257 / 382

Group 03
General Maintenance and Diagnostic Data
GENERAL TROUBLESHOOTING
In the event the lift truck does not operate correctly, a
status code is displayed on the display panel. Once
the status code is obtained, follow the procedures out-
lined in this manual only after reviewing the following
information regarding the truck’s unique electrical sys-
tem and troubleshooting procedures.
NOTE: Due to the interaction of the traction controller
with all truck functions, almost any status code or con-
troller fault could be caused by an internal failure of
the traction controller. After all other status code pro-
cedures have been followed and no problem is found,
the traction controller should be tested and replaced
as the last option to correct the problem.
Prior to troubleshooting systems and components on
the vehicle, ensure the battery voltage is correct and
within specifications. Make sure the battery connector
contacts are clean of corrosion and the battery polar-
ity within the connector is correct. Inspect that all
fuses are correct and are not the cause of component
failure. Ensure the key switch is in the ON position
when conducting voltage checks or verifying the oper-
ation of a component. Make sure the brake switch is
functioning properly and is closed.
Many faults noted by lift truck’s electrical system may
be the result of loose wiring connections and/or bro-
ken or shorted wiring within the lift truck. Begin the
troubleshooting process by carefully inspecting the
wiring involving the device or devices noted by the on-
board diagnostic system. .
The controllers are sealed units with no serviceable
components. Troubleshooting is usually limited to ac-
cessing status codes and following the diagnostic pro-
cedure provided for each status code.
Use standard testing procedures to verify inputs and
outputs when necessary.
CAUTION
Never attempt to probe through the back of the
connector plugs of the motor controller. These
plugs are special sealed plugs. Probing through
the back of the plugs will destroy the seal and can
cause a short circuit. If a circuit must be tested for
voltage, check for voltage at an amp-type plug, a
switch, or component. If a circuit is suspect,
check the circuit for continuity by disconnecting
the plug and testing continuity from the front (pin
end) of the plug.
Standard probes are too large to be inserted into
the center of female pins (sockets) of the special
sealed plugs and can damage or expand the pins.
Expanded pins will not provide good connections
once the plug is reconnected. The connectors are
shaped to allow the insertion of a small flat-blade
screwdriver into the connector. After inserting the
screwdriver into the connector, attach probes
with alligator clips to the shank of the screwdriver
to obtain readings.
Refer to 8000 YRM 1512 for wiring diagrams and ad-
ditional circuit information.
ELECTRICAL SYSTEM General Maintenance and Diagnostic Data
Check the Service Manual section in Yale Axcess Online for possible updates and check pertinent Bulletins
9030-03-1