Gesture and Motion Evaluation Kits (Digital) USEQMSK_____00
The above information is believed to be correct but does not purport to be all inclusive and must be used only as a guide.
© KEMET Electronics Corporation • KEMET Tower • One East Broward Boulevard
Fort Lauderdale, FL
33301 USA • 954-766-2800 • www.kemet.com
6
Figure 3
– Com Port Selection
Connect to the port that is listed once the device is connected. If more than one COM port is
listed this can be checked by disconnecting the device and refreshing the list. Re-connect and
refresh the list then select the COM port that has appeared and click
Ok
.
Once the device has been selected the software runs through a calibration sequence. Whilst
the calibration sequence is running, the arrow that indicates a gesture direction will spin round
and then vanish upon completion of the calibration. This is required when using the device
without a method of stopping drafts from running across the device.
4.3
Different Variations
The software will automatically determine the type of kit when it is plugged in.
Figure 6
–
USEQMSKS221600
and
USEQMSK1220900
Gesture Sensing Kits
Figure 7
–
USEQMSKL011600
Motion Sensing Kit
Figure 8
–
USEQMSKL221600
Directional Motion Sensing Kit
