80
WIRES-X Software
Main Menu
●
Call settings
Round QSO Room connection ....................Set the operation when receiving a connection request to a room on the Internet.
ON (with a check-mark) .......... Allows the connection to a room when requested
(default setting).
OFF (without a check-mark) ... Rejects the connection when requested.
Caution
When the “Return to Room” checkbox is checked and a connection room is set,
the connection will be initiated automatically regardless of the “Round QSO Room
connection” setting.
Accept calls while in Round QSO Rooms ...Set the operation when receiving a connection request from another node while
connecting to a room on the Internet.
ON (with a check-mark) .......... Severs the connection to the room and initiate the
connection to the node when requested.
OFF (without a check-mark) ... Rejects the request (keeps the connection to the
room) (default setting).
Caution
If a connection request is received while nodes on the room are communicating, the
request is rejected regardless of this setting.
Back to Round QSO after disconnect ..........Set the operation when the connection is severed from the node after accepting its
connection request while “Accept calls while in Round QSO Rooms” is set to ON.
ON (with a check-mark)
Reconnects to the room your node was connected to
before accepting the interrupt connection request.
OFF(without a check-mark) Does not reconnect to the room (remains in not
connected mode) (default setting).
Return to Room ...........................................Set whether or not to connect to the room specified from “Room ID” every time.
ON (with a check-mark) .......... Connects to the specified room every time the
WIRES-X software starts.
OFF (without a check-mark) ... Connects to the specified room not every time
(default setting).
Tip
The #55555 command can also change this setting (When “DTMF #55555” is set to ON).
The operating conditions are as follows when this function is set to ON.
• Connecting time belt ... 24 hours
• Maximum number of times for retrying connection
..................................... 10 times (If connection cannot be established after sending
connection requests 10 times, set the function to OFF. To
