20
Scanning
FTM-3100R/E Advance Manual
Scanning the programmable memory channels
1. Press the [
V/M
(
MW
)] key to enter memory mode.
2. Turn the
DIAL
knob, or use the microphone keypad, to recall the upper or lower fre-
quency PMS memory channel (L1 or U1).
3. Press the [
#
] key on the MH-48A6JA Microphone.
“P1” appear on the right side of the display.
4. Press and hold [
UP
] or [
DWN
] on the microphone for over one second.
Programmable memory scanning will begin.
Note:
To stop programmable memory scanning, press
PTT
on the microphone (this does
not cancel PMS mode).
To cancel PMS mode, when programmable memory scanning stops, press the [
#
]
key on the MH-48A6JA Microphone.
Band Edge Beeper
The FTM-3100R/E will automatically “beep” when the receive band edge is encountered
during scanning (either in standard VFO scanning or during PMS operation). Additionally,
the band edge beep feature may be enabled to sound when the band edge frequency is
reached while tuning the VFO, using the
DIAL
knob.
The procedure to enable the Band-Edge Beeper (during manual tuning) is:
1. Press and hold in the [
MHz
(
SETUP
)] key for
one second, then rotate the
DIAL
knob to
select “
BEP EDGE 4
”.
2. Press the [
MHz
(
SETUP
)] key, and then ro-
tate the
DIAL
knob to set this Menu item to
“ON”.
3. Press and hold in the [
MHz
(
SETUP
)] key for
one second to save the new setting and exit
to normal operation.
VOL
DIAL
D W
M W
SETUP
REV
SQL
TXPO
V / M
M H z
