4
Name and function of each component
Panel (front)
VOL
knob
Rotate the VOL Knob to adjust the audio
volume level.
VOL knob (Upper): A-Band
VOL knob (Lower): B-Band
Full color screen display
DIAL knob
DIAL
knob (Upper): A-Band
DIAL
knob (Lower): B-Band
•
Press the
DIAL
knob to enable setting the
operating band frequency in 1 MHz units.
•
Press and hold the
DIAL
knob to enable setting
the frequency in 5 MHz units.
•
Press the SQL key, then rotate the
DIAL
knob to
adjust the squelch level.
GM key
•
Press to turn the GM (group monitor) function
ON/OFF.
(For details on the function, refer to the GM Func-
tion Instruction Manual which may be downloaded
from the Yaesu website.)
•
Press and hold to enter DG-ID number setting
screen.
1. Rotate the
DIAL
knob to select [
DG-ID TX
]
(Transmit DG-ID number), and then press the
DIAL
knob.
2. Rotate the
DIAL
knob to select the DG-ID
number from 00 to 99, and then press the
DIAL
knob.
3. Similarly, set [
DG-ID RX
] (receive DG-ID
number).
•
While setting the DG-ID number, pressing
and holding the
DIAL
knob will set the
transmit and the receive DG-ID numbers to
“00”.
D X
key
•
Each time this key is pressed for a short time the
communication mode changes:
AMS(
/
) → DN → DN → DN ...
Normally, the communication mode is automatically
set to the mode of the partner station, by setting to
“AMS” (AMS display example:
/
), which can
receive the signal of the partner station.
•
Press and hold the [
D X
] key to start the
WIRES-X.
The WIRES-X enables long-distance communication
in digital communication systems via the Internet.
(For details on this function, refer to the WIRES-X
Function Instruction Manual which may be
downloaded from the Yaesu website.)
•
Press and hold the [
D X
] key again to return to
the normal operation screen.
BACK key
Press the [BACK] key to return to the previous
screen.
F(SETUP) key
•
Press the [
F(SETUP)
] key to display the func-
tion menu screen. Rotate the
DIAL
knob to
select an item and perform the functions and
make settings.
•
Press and hold the [
F(SETUP)
] key to enter
set-up menu. The Set Mode permits configuring
the various functions according to individual op-
