52
Band Scope
The
VFO
mode displays the current frequency as the center, and the memory mode
displays the current memory channel as the center, and displays the signal status upper
and lower channels with a
Band Scope
. The center frequency and memory channel can
be changed by turning the
DIAL
knob.
Press the [
DISP
] key.
The band scope of the
VFO
currently used is displayed,
and the received audio may be heard.
While the Band Scope is displayed, the other
VFO
cannot
be received.
VFO mode:
The status (strengths) of the signals in the upper and
lower frequency channels (61CH) centered on the cur-
rent receive frequency are displayed in the graph.
Memory Mode:
The status (strengths) of the signals in the upper and
lower memory channels (21CH) centered on the current
memory channel are displayed in the graph.
z
Change frequency or Memory Channels
Rotate the
DIAL
knob to change the receive frequency or memory channel at the
center of the band scope.
z
Exit the Band Scope
Press the [
DISP
] key or the [
BACK
] key.
The Band Scope frequency interval is the same as the
VFO
frequency step.
z
Change the number of channels displayed
1. Press and hold the [
F(SETUP)
] key.
2. Rotate the
DIAL
knob to select [
DISPLAY
], then press the
DIAL
knob.
3. Rotate the
DIAL
knob to select [
3 BAND SCOPE
].
4. Press the
DIAL
knob to select “
WIDE
” or “
NARROW
”.
The number of channels displayed in each mode is as follows:
WIDE
NARROW
VFO mode
61 channels
31 channels
Memory mode
21 channels
11 channels
Factory default value: “
WIDE
”.
5. Press the [
DISP
] key to complete the setting.
