25
Using the Voice Guide unit FVS-2
The receive audio can be recorded and then played back later using the optional voice
guide unit “FVS-2”. The frequency of the operating band can also be announced by
voice when the announce function is set to ON.
Mounting the voice guide unit “FVS-2”
z
Preparations
• Voice guide unit “FVS-2” (optional)
• Plus driver
z
Mounting procedure
• Avoid touching the electronic components with your hands as the semiconductors may be
damaged by static electricity.
• Note that labor charges to install optional items by our customer service support staff shall
be separately chargeable.
1. Turn the transceiver OFF.
2. Turn the external power supply OFF.
3. Unplug the control cable, microphone, and DC power supply cables from the main
chassis.
4. Remove the eight screws from the main body, four on
top and two each at the sides.
5. Carefully lift the top cover of the main body.
Do not lift the top cover by force. This may result in
cables connected between the circuit boards and the
speaker inside the cover to be cut.
Speaker Cable
6. Unplug the speaker cables extending from the top cover from the socket on the
board inside the main body before removing the cover.
Hold the connector when unplugging the cable without pulling on the cable itself.
