PROGRAMMING YAESU FTH-2006
Programming this rig needs only a small screwdriver and some skill, no computer or
interface cords are needed.
Normally this rig display only a channel number "
CH 0
" to "
CH 9
" if all memories
where programmed.
You can't modify the frequency with the 4 keyboard's keys. But there are some (4)
hidden keys somewhere to achieve this.
A) Right of the display, remove the keyboard plastic cover with a small screwdriver or
a knife (it's glued) and you will see 4 additional keys on the keyboard just under the
originals.
B) Those keys are like this:
1) Power on the rig
2) Change display from channel to frequency by pressing once the "hidden"
"
Channel/Frequency
" key.
3) Adjust to the desired frequency using the big upper right knob or "
Scan +
" or
"
Scan –
" keys (You can obtain a 1 MHz step depressing the "
Function
" key
before turning the knob or "
Scan +
" or "
Scan –
" keys.
4) From the frequency display, press the "
Function
" key (a small F is displayed)
and quickly press the "
Channel/Frequency
" key, a small blinking memory
number will appear in the upper left corner of the display, change the memory
number using the big upper right knob or "
Scan
+
" or "
Scan –
" keys and press
again the "
Channel/Frequency
" key to store the memory.
5) Back to "channel display" mode using the "
Channel/Frequency
" key, the
desired frequency is stored in the chosen memory.
Summary of Contents for FTH-2006
Page 3: ...That s all Enjoy F6BXM...
