82
16 Setting the frequency offset for Repeater Shift
RPT SHIFT FREQ Function
Set the repeater shift offset frequency.
1. Press and hold the [
DISP
] key, and then touch [
CONFIG
].
2. Rotate the
DIAL
, then touch [
16 RPT SHIFT FREQ
].
3. Rotate the
DIAL
knob to select the desired shift offset.
4. The offset frequency can be set in steps of 0.05 MHz between 0.000 MHz and
150.000 MHz.
Remark
The default setting differs depending frequency
17 Disabling Receiver While No Signal Is Received
Receiver Battery Save Function
Sets the Receive OFF Battery save interval (sleep ratio) to reduce power consumption.
1. Press and hold the [
DISP
] key, and then touch [
CONFIG
].
2. Rotate the
DIAL
, then touch [
17 SAVE RX
].
3. Rotate the
DIAL
knob to select the desired setting (the time interval for disabling the
receiver operation).
0.2 sec (1:1) to 1.0 sec (1:5)
In steps of 0.1 second
to 1.0 sec (1:5) to 10 sec (1:50)
In steps of 0.5 second
to 1.0 sec (1:50) to 60 sec (1:300 sec)
In steps of 5 second
OFF
Disables the Battery save function.
4. Selecting OFF disables this function.
Remark
The default setting: 0.2 sec (1:1)
18 Changing the Frequency Step Manually
Rotate the
DIAL
knob to select [
18 STEP
] to set each frequency step, when the Dial
Knob is turned manually.
For additional details, refer to the Advanced Manual which may be downloaded from the
Yaesu website.
19 Setting Clock Time
Set the date and time function of the built-in clock of the FT3DR/DE.
In the factory settings, the date and time are automatically set when positioning the GPS
signal, so in this case no manual setting is necessary.
1. Press and hold the [
DISP
] key, and then touch [
CONFIG
].
2. Rotate the
DIAL
, then touch [
19 DATE & TIME ADJ
].
3. Rotate the
DIAL
knob to select the year, month, day, hour and minute.
4. To activate the time signal (alarm goes off every hour on the hour), touch [SIGNAL].
The checkbox will be checked.
5. Touch [OK].
