Page 93
FT
DX
9000 C
ONTEST
O
PERATION
M
ANUAL
CW C
ONVENIENCE
F
EATURES
C
ONTEST
M
EMORY
K
EYER
Text Message Programming
1. Press the CW Mode key (#
) to set the operating
mode to CW.
2. Be sure that Break-in is Off by pressing the BK-IN/
SPOT key (#
), if necessary.
3. Press the FH-2’s MEM key.
Checking the CW Memory Contents
1. Be sure that Break-in is still turned Off.
2. Press the FH-2’s 1 ~ 5 key to check your work.
You will hear the results in the sidetone, but no RF
energy will be transmitted.
LOCK
OFF
ON
LOCK
OFF
ON
LOCK
OFF
ON
LOCK
OFF
ON
LOCK
OFF
ON
4. Press the FH-2’s 1 ~ 5 key to select the desired
Message Memory Register into which you wish to pro-
gram the text.
5. Use the FH-2’s
and
keys to set the cursor
position and use the
and
keys to choose
the letter/number to be programmed in each slot of
the memory. In the case of the second example above,
the “}” character designates the slot where the Con-
test Number will appear.
Advice
You may also use the Main Tuning Dial (#
) and the CLAR/
VFO-B knobs (#
) to program the message characters.
6. Press the FH-2’s MEM key again once all charac-
ters have been programmed.
On-The-Air CW Message Playback
1. Press the BK-IN/SPOT key to enable transmission.
Either Full- or Semi-break-in will be engaged, depend-
ing on the setting of Menu item “
MODE-CW 047
CW BK-IN
.”
2. Press the FH-2’s 1 ~ 5 key to transmit the pro-
grammed message.
Note
If you subsequently decide to use the “MESSAGE” technique for
memory storage, please note that the contents of a message stored
using text input will not be transferred over when you select “MES-
SAGE” on a particular memory register.
Correcting/Editing Previously-Stored
Characters
Use the Main Tuning Dial knob (#
) to select the letter/num-
ber to be corrected, then rotate the CLAR/VFO-B knob (#
)
to choose the revised letter/number top be utilized in this slot.
Deleting Previously-stored Characters
Use the Main Tuning Dial knob (#
) to select the last cor-
rect letter in the message. Now rotate the CLAR/VFO-B knob
(#
) to select the “ } ” character; everything after the “ } ”
character will be deleted.
Summary of Contents for FT DX 9000 CONTEST - 2
