Yaesu FT-7900R, Operating Manual, Page: 36 / 84

34 FT-7900R O
PERATING
M
ANUAL
Storing Independent Transmit Frequencies (“Odd Splits”)
1. Store the receiving frequency using the method already described.
2. Turn to the desired transmit frequency, then press and hold in the [
V/M
(
MW
)] key for
1/2 second.
3. Within ten seconds of pressing the [
V/M
(
MW
)] key, use the
DIAL
knob or microphone’s
[
UP
]/[
DWN
] buttons to select the same memory channel number as used in step 1 above.
4. Press and hold in the
PTT
switch, then pressing and holding the [
V/M
(
MW
)] key for
1/2 second while holding the PTT switch to save the entry and exit to normal operation.
This will not cause transmission; instead, it signals the microprocessor that a separate
transmit frequency is being programmed into that memory register.
Whenever you recall a memory which contains indepen-
dently-stored transmit and receive frequencies, the “
”
indication will appear in the display.
If you set the CTCSS/DCS functions to the receiver frequency and transmit frequency indi-
vidually, the “Odd Splits” feature can be memorize the frequency/code individually for trans-
mit and receive.
Whenever you recall a memory which contains indepen-
dently-stored CTCSS/DCS functions, the decoder icon will
appear and the encoder icon will blink in the display.
To confirm the memorized frequency/code:
1. Press and hold in the [
BAND
(
SET
)] key for 1/2 second to enter the Set mode.
2. Rotate the
DIAL
knob to select Menu #9 (
DCS.COD DCS.COD
DCS.COD DCS.COD DCS.COD
)
when the receiver CTCSS/DCS function is set to “DCS”,
or select Menu #44 (
TN FRQ TN FRQ
TN FRQ TN FRQ TN FRQ
) when the receiver CTCSS/
DCS function is set to “TONE SQUELCH”.
3. Press the [ BAND
(
SET
)] key momentarily to display the
memorized frequency/code for the receiver.
4. Press and hold in the [ TONE
(
HM/RV
)] key for 1/2 sec-
ond to display the memorized frequency/code for the
transmitter. You can confirm the Transmit and Receive
TONE/DCS by alternately press and holding of the
[
TONE
(
HM/RV
)] key.
5. Press and hold in the [ BAND
(
SET
)] key for 1/2 second to exit to normal operation.
R
EGULAR
M
EMORY
C
HANNEL
O
PERATION
M
EMORY
O
PERATION
: Receive TONE/DCS
: Transmit TONE/DCS