Yaesu FT-4VE, Operating Manual

Page: 31 / 40

29
Restoring to Defaults (Reset) / Setting the Preferred Operating Mode
The following reset or preferred operating modes may be selected.
1. Turn the transceiver
OFF .
2. Press and hold the MONI/T.CALL key and
the PTT switch simultaneously, while turning
the transceiver ON.
3. When the LCD backlight comes on, release
the MONI/T.CALL key and PTT switch.
4. Referring to the below table, press the [▲] or
[▼] key to select the desired resets or desired
operating modes.
5. Press the Function key momentarily to acti-
vate the selected operating mode.
Display Description
F1:SET RST
Resets the Set Mode settings to factory defaults.
F2:MEM RST Clears the Memory settings to factory defaults.
F3:MB. RST Clears the Memory Bank assignments.
F4:ALL RST Clears the all memories and other settings to factory defaults.
F5:M-ONLY
Memory Mode operation only.
F6:CLONE Clone Mode.
CAUTION!
Resetting the transceiver (F2 MEM RST / F4 ALL RST) will clear all
memories.
Always make a note of the memory channel settings, etc. before
resetting.
• To cancel this operation, turn the transceiver OFF.
• Perform F4:ALL.RST to restore all of the following Set Mode items to default.
10 DCS.COD 26 PSWD 27 PSWDWT 30 RPT.FRQ 31 RPT.SFT
35 SKIP 36 SQL.TYP 37 STEP 38 TN FRQ 40 TX PWR
45 W/N.DEV