Yaesu FT-2980E, Operating Manual

Page: 36 / 80

Memory Recall
Once you have stored the memory or memories desired, you must now switch from the
“VFO” mode to the “Memory Recall” mode, so you can operate on the just-stored memory
channels.
1. Press the [
D/MR
(
MW
)] key, repeatedly if necessary, un-
til the “ MR ” icon and a memory channel number appear
on the display; this indicates that the “Memory Recall”
mode is now engaged.
2. When more than one memory has been stored, use the
DIAL
knob to select any
of the programmed memories for operation. Alternatively, the microphone’s [ UP
] or
[
DWN
] button may be used to step or scan through the available memories. When
using the microphone’s buttons, press the button momentarily to move one step up
or down; press and hold in the [
UP
] or [
DWN
] button for one second to begin memo-
ry scanning.
Memory Recall from the Microphone’s Keypad:
While operating in the Memory Recall mode, the keypad of the MH-48A6J Microphone
may be used for direct recall of memory channels.
To do this, press the Channel Number you wish to recall, then press the [
#
] key. For
example, to recall Memory Channel “ 5 ”, press [ 5
]

[ #
]. To recall Memory Channel “
118 ”,
press [
1
]

[
1
]

[
8
].
You may also recall Programmable Memory Scan (PMS) channels (“
L0
/
U0
” through “
L9
/
U9
”) using the following numbers: Programmable Memory channels #
L0
= “200”,
U0
=
“201”,
L9
= “218”, and
U9
= “219”.
32
Memory Operation
FT-2980R/E Operating Manual