Yaesu ADMS-12, Instruction Manual

Page: 9 / 30

Execute ADMS-12
To open the ADMS-12 software, double-click the “ FTM-300D ADMS-12 EXP ”
icon on the computer desktop.
● To close the ADMS-12 software
Click “Exit” in the “File” menu to close the ADMS-12.
Be sure to read the transceiver data information before using ADMS-12
It is necessary to read the data information from the transceiver first. If the data is not read, it will not be
possible to load the saved file or transfer the data to the transceiver. Read the FTM-300D data information
from the transceiver by the following either the microSD card or PC connection cable procedure, before
editing the data with ADMS-12.
Use a microSD card
1. Save the FTM-300DR/DE data to the microSD card by selecting “ SD CARD ”

“ 1 BACKUP ”

“ WRITE TO SD ”

“ ALL ” from the FTM-300DR/DE setup menu.
2. Insert the microSD memory card with the saved “ ALL ” data from FTM-300DR/DE to the PC.
3. Click [ Get Data from SD card ] in the “ Communications ” menu, then click “ ALL ”
Select the “ CLNFTM300D.dat ” file in the “ FTM-300D ” folder - “ BACKUP ” folder of the microSD card
drive.
(root)
FTM300D
BACKUP ALL settings data (CLNFTM300D.dat)
4. Click the [
Open
] button.
5. Click the [
OK
] button.
When the data transfer is complete, the template screen which was imported from the FTM-300DR/DE via
the microSD memory card will appear on the ADMS-12 screen.
Use a PC Connection Cable
1. Connect the FTM-300DR/DE to the PC using the PC connection cable SCU-56 or SCU-20, CT-163.
2. When using for the first time, please refer to “ COM port setting ” (Page 18) to set the COM port to
which the FTM-300DR/DE is connected.
3. Press and hold the [ F(SETUP) ] key on the FTM-300DR/DE.
4. Turn the DIAL knob to select [ CLONE ] and press the DIAL knob.
5. Turn the DIAL knob to select [ 1 This → Other ] and press the DIAL knob.
6. Click [ Get Data from FTM-300D ] in the “ Communications ” menu.
7. Click the [ OK ] button.
8. Rotate the DIAL knob to select [ OK ] on the FTM-300DR/DE, and press the DIAL knob.
A bar graph will be displayed and data transfer will start.
9. Click the [ Close ] button.
8