Unpacking
Product Overview & Accessories
Nobel 1.0A is shipped with the following parts and accessories. After unpacking,
please inspect the interior and exterior of the printer and accessories for damage.
Please contact support for any missing or defective parts and accessories.
④
Select “UTILITIES” > “MOVE
PLATFORM”>“TO TOP”>“YES”
to raise the platform.
⑤
Remove the protective foam.
*Keep original packaging material in the
event of sending your unit back for repair.
Setting Up
Install and prepare the following parts before printing:
①
Install the resin tank by pushing
the tank all the way into its slot.
⑥
Shake the resin cartridge for about
10 seconds.
⑦
Assemble the nozzle cap and the
inner tube, and replace the bottle
cap with the assembled nozzle cap.
②
Calibrate the platform by selecting
"UTILITIES" > " HORIZON CALIB" and
follow the instructions on the screen.
After removing prints from the
platform, loosen 4 small screws over
the platform. And press OK and wait
until the platform has descended.
Quick Start Guide
Welcome to your Nobel 1.0A Please read this guide carefully for tips on unpacking,
setting up, printing, and post processing to ensure an excellent 3D printing experi-
ence!
①
Upon receiving your printer, remove
the packaging materials, plastic bag,
tapes, and the accessory tray, and
assemble the lid by following the
instruction in the box. Then, remove
the protective foam from under the
platform according to the procedure
below:
-1-
(US) XYZprinting, Inc. Address: 9877 Waples Street, San Diego, CA 92121 Website: http://us.xyzprinting.com
Online Customer Service Desk: http://support.xyzprinting.com/us_en/Help/ticket/home
ENGLISH
③
Connect the printer to a power
source and turn on the printer. (Please
do not use the power adapter for
Nobel 1.0 on this model.)
②
Lay down the printer, and release
the printing module lock by pushing it
to the right.
Follow the procedures to
remove the protecting foam under
the platform.
Platform
Quick Start Guide
Filling Tubes
Cartridge Slot
Tank Slot
Operation Panel
Lid
Resin Tank
Rinse Basket
Gloves
Scraper
USB Flash Drive
Inner Tube
Nozzle cap
Power Cable
Power Adapter
Starter Resin
USB Wire
Power Jack
USB Wire Port
USB Drive Port
(Back View)
Power
Switch
Warranty
Card
(Bottom of the printer)
F1
F2
B1
B2
⑤
Tighten the
screws with a coin
or other tools
(sequence from
F1, B1, F2 to B2)
and press [OK] to
F1
F2
B1
B2
④
Place both
hands over the
platform to make
sure the surface is
adhered to the
resin tanks. At the
same time, tighten
③
Press the
platform with
both hands 3
times. Make sure
you see the right
side of the tank
sinks into the tank slot slightly. Free
you hands from the platform for a few
seconds so the silicon finish on the
tank can reshape. Check the tank frame
has repositioned (there's no gap
between the black frame holders).
the fronts crews (F1, F2) with fingers
and then the screws at the back (B1,
B2). And then release both hands from
the platform, fasten the 4 screws firmly.
complete calibration.
