Managing Initialization Parameters
DEFINE [SERVER] CHASSIS SLOT LOADDUMP LINK
Specify a link selection for an initialization record
The DEFINE CHASSIS SLOT LOADDUMP LINK command specifies a
selection from the link map for an initialization record. The processor
module uses the link selection to obtain the software load image and
parameter file from a destination on the network, or to send information
to a dump server.
Notes
The information you specify on the command line associates the link
with either a midplane Ethernet segment or an external connection.
Some combinations of keywords are not valid for some products. If you
attempt to specify a selection that is not valid for a product, the command
interface generates an error message. See Chapter 3 for more
information about the valid connections in the link map for each product.
Table 4-2 in this chapter lists the default link selections in the primary,
secondary, and tertiary initialization record for each product.
The link selection you specify for an initialization record appears on the
List/Monitor Chassis Slot Loaddump Characteristics display.
You cannot change the link selection with this command on managed
concentrators. You can change the link selection through the
initialization configuration menu, product-specific commands, or
SNMP. See the manual Managing the Xyplex Ethernet Repeaters for
more information about these product-specific commands.
Privilege
Level
Privileged
Syntax
DEFINE [SERVER] CHASSIS SLOT [list] LOADDUMP [record|ALL]
LINK identifier selection
Where
Means
One or more chassis slot numbers in the range of 1-15. The local slot is
the default.
[list ]
One or more of the following initialization records:
PRIMARY
SECONDARY
TERTIARY
ALL
The PRIMARY initialization record is the default.
[record]
74
0020
