Xylem OxiTop Control OC 100, Operating Manual

Page: 29 / 84

OxiTop
®
Control OC 100 Operating mode: BOD Standard / BOD Routine
ba31114e07 08/2014
29
5.4.3 Showing the measuring head list
This function is used to allocate individual measuring heads to the rele-
vant sample in the
SAMPLE STATUS TYPE list ( sample management)
and to find individual measuring heads.
5.4.4 Calling up data
This function is used to call up the data of individual samples.
To call up the data of all samples, see section 5.3 C
ALLING UP ALL DATA
,
page 24.
Select the -

list menu item
with <

><

>
The list of measuring heads of
the selected sample is displayed
together with the serial numbers
of the measuring heads.
(In the
BOD Routine operating
mode, this list always contains
only one measuring head.)
Point the controller at the measuring
heads:
Use <

><

> to select a measuring head and confirm with
<RUN/ENTER> .
The controller repeatedly transmits the call up of the selected
measuring head. The measuring head flashes for approx. 5
seconds.
Use <ORG> to return to the SAMPLE STATUS TYPE list
( sample management).
RUN/ENTER
40 cm to 1 m