7
FW: 841013-005/843003-001
Turbidity and Suspended Solids Transmitter
EN 5.10 SuSix Manual 2007
1. Introduction
Thank you for choosing the MJK SuSix
®
Turbidity and Suspended Solids
Transmitter. We have done our utmost to design and manufacture a quality
transmitter that satisfies your requirements.
The SuSix
®
Transmitter, consisting of a sensor, a converter and a display,
is easy to install, calibrate and put into service. However, read this manual
first to get familiar with the SuSix
®
Transmitter and all its features.
The equipment must be handled and operated as instructed by the
manufacturer, MJK Automation to ensure stable operation and accurate
measurements.
The SuSix
®
sensor is equipped with two light-emitting diodes (LEDs,
transmitters) and four emitter diodes (receivers). The readout is based on
several measurements utilizing all the diodes to compensate for errors like
dirt adhesion, worn diodes or scratches on the lenses.
SuSix
®
is available in two versions – a sensor with or without a dirt wiper
and a screw thread for submerged installation in tanks or a fitting for instal-
lation in tubes. The principles for use are identical for both versions.
You can always contact your local representative or the MJK hot lines for
advice and guidance:
•
Europe
Tel.: +45 45 56 06 56 E-mail: [email protected]
•
Denmark
Tel.: +45 45 56 06 56 E-mail: [email protected]
Visit our web sites at
to learn more about MJK Automation,
our other products and the people behind them.
SuSix
®
is a registered trademark of MJK Automation A/S, Denmark.
MJK
Blokken 9
DK-3460 Birkerød
Denmark
MJK Automation is a Xylem
Brand
