en - Original instructions
20
Genyo plus, Additional Installation, Operation and Maintenance Instructions
5.2.2
AUT mode
AUT mode, starting of the pump unit and instant visualization of the pressure and current.
Phase
Action
Illustration
1
To view the pressure with
the unit OFF:
press once and Aut
appears, followed by the
instantaneous pressure
value (bar or psi)
2
Press several times to
view, in alternation, the
pressure (bar or psi) or the
instantaneous current (A)
5.2.3
Setting the current
Set the nominal absorbed current of the motor upon initial start-up or when the default
parameters are loaded or the unit is replaced.
Phase
Action
Illustration
1
With the unit in OFF
mode, press several times
to view the instantaneous
current (A)
2
Press once: the display
flashes and shows the
current value
3
Edit the value
