Xylem Goulds ResiBoost RB111512, Instruction Manual

Page: 15 / 40

Number Component Included in the kit Notes
1 Electric pump √ eHM
2 Union with check valve √
3 Minimum pressure switch
to prevent dry running (or
other level control switch)
4 Electric pump bleed /
priming cap
5 Vacuum pressure gauge
6 Filter
7 Non-return valve with filter
(foot valve)
8 Discharge pressure gauge
9 Union
10 Pressure relief valve Plumb to drain
11 Gate valve
12 Diaphragm tank √ V2L ( 2 liter tank)
13 ResiBoost controller √
14 Controller power panel
15 Storage tank
16 Float switch
4.4 Electrical installation
Precautions
NOTICE:
• Make sure that all electrical connections are performed by qualified installation
technicians and in compliance with the regulations in force.
• Before starting work on the unit, make sure that the unit and the control panel are
isolated from the power supply and cannot be energized.
• Make sure all plumbing connections are made prior to wiring the unit.
4.4.1 Grounding (earthing)
Electrical Hazard:
Always connect the ground (earth) connection before making other electrical
connections.
4.4.2 Power supply connection
WARNING:
Always turn off the power supply, lockout power and wait a minimum of 2 minutes before
making any electrical connections.
The controller comes with an input power cable and a motor power cable to allow
flexibility in positioning the controller. After plumbing the system, position the controller
for access to the user interface.
NOTE: The controller must be connected to a GFCI. Use either a GFCI circuit breaker or
GFCI outlet.
4 Installation
ResiBoost INSTRUCTION MANUAL 13