Xylem GOULDS e-SVE Series, Instruction Manual, Page: 30 / 52

Display Mode Description
ON ON Pump on; the motor starts following
the selected control mode.
It appears for a few seconds when
contacts 11 and 12 (see Par. 5.4) are
short circuited and the pump is not in
STOP mode.
To manually set the pump to ON
mode:
• Example A:
– HCS, MES, MSY control
modes that reach a required
value (head) of 4.20 bar,
starting with a minimum
value of 0.5 bar after manual
stop: STP
→ press →
ON
→
once after a few
seconds… → 4.20 BAR.
• Example B:
– ACT control mode that
reaches a requested value
(speed) of 200 10xRPM,
starting with a minimum
value of 80 10xRPM after
manual stop: STP
→
press
→
ON
→
once, and
after a few seconds…
→
200 10xRPM.
With the pump in operation, it is
possible to display the Actual Head
and the Actual Speed:
• Example A:
– HCS, MES, MSY control
modes with Actual Head
4.20 bar and corresponding
Actual Speed of 352
10xRPM: 4.20 BAR
→
+
→
352 10XRPM
→
after 10 seconds or +
→
4.20 BAR.
• Example B:
– ACT control mode with Actual
Speed 200 10xRPM and
corresponding Actual Head
of 2.37 bar: 200 10xRPM →
+
→
2.37 BAR
→
after 10 seconds or +
→
200 10xRPM.
6.5.2 Parameters menu visualization
The parameter menu gives the possibility to:
• select all the parameters (see Par. 6.5)
• access Parameter View / Editing (see Par. 6.2).
6 System Setup and Operation
28 Smart Pump Range INSTRUCTION MANUAL