Xylem GOULDS e-AB Series, Instruction Manual

Page: 30 / 56

LED Status
Off RS–485 or wireless connection faulty or missing.
Flashing The unit is exchanging information with the
communication module.
6.4.5 Units of measurement
LED on Measurement active Notes
10xRPM Impeller rotation speed The display shows the speed in
10xRPM
BAR Hydraulic head The display shows the value of
the head in bar
PSI The display shows the value of
the head in psi
6.5 Display
6.5.1 Main Visualization
Display Mode Description
OFF OFF Contacts 11 and 12 (see parameter 5.4) are not short-circuited.
Note: It has lower display priority than STOP mode.
STP STOP Pump stopped manually.
If the pump is switched on after setting P04 = OFF (see Par. 6.5.1), it is
stopped so that the motor is not in operation, and STP flashes (STP →
STP).
To manually stop the pump:
• Example A:
– HCS, MES, MSY control modes with initial required value (head) of
4.20 bar and minimum value 0.5 bar:
4.20 BAR
→
press → STP once.
• Example B:
– ACT control mode with initial required value (speed) of 200
10xRPM and minimum value 80 10xRPM: 200 10xRPM →
press → STP once.
6 System Setup and Operation
28 Smart Pump Range INSTRUCTION MANUAL