Xtreme Manufacturing XRM945, Operation & Safety Manual

Page: 55 / 76

For information call (800) 497-1704
Page 55
XRM 9 45 Operation
Shifting Gears
 Warning
DO NOT shift through multiple gears with
a single turn of the gear select lever. Allow
the engine speed to slow down before
shifting to the next lower gear. Improper
use of the gear select lever could cause transmission
damage or forklift tip over/roll over and result in
injury or death.
The transmission has four (4) gears that can be used for
traveling in forward or reverse.
To shift gears rotate the gear select lever to the next gear
while the forklift is traveling.
• Use first gear (1) for highest torque and pulling power.
• Use higher gears for higher ground speed.
• Never travel in fourth gear (4) when carrying a load.
• Allow the engine speed to slow down before shifting to
a lower gear.
Warning Indicators and Gauges
 Caution
Check warning indicators and gauges
on the dash panel frequently during
operation. If a warning indicator is
illuminated or a gauge shows abnormal
readings, stop the forklift, follow proper shut down
procedures, tag the forklift with “Do Not Operate”
tags, and have a qualified mechanic service or repair
the forklift BEFORE placing it into service again.
There are three (3) warning indicator lights on the dash
panel that illuminate during critical circumstances. All
three (3) warning indicators demand immediate attention
and forklift servicing. In many cases the forklift should
be shut down as soon as practical to prevent serious
mechanical failure.
The hydraulic oil temperature indicator illuminates when
the oil temperature is above 195°F (191°C). Stop and idle
the engine, allowing time for cooling. If the indicator does
not go out after five (5) minutes, shut the engine down.
Figure 7-17. Hydraulic Oil Temperature Indicator.
The low brake pressure indicator illuminates if the
hydraulic brake oil pressure gets low.
If the low brake pressure indicator is illuminated, stop
the forklift, follow proper shut down procedures, tag the
forklift with “Do Not Operate” tags, and have a qualified
mechanic service or repair the forklift BEFORE placing it
into service again.
Figure 7-18. Low Brake Pressure Indicator.