Xtramus NuTAP-311, User Manual

Page: 52 / 60

52
E-mail: sales@xtramus.com
Website: www. Xtramus.com
XTRAMUS TECHNOLOGIES ®
6.6. Monitor Port Setting
You can configure filtering/capture criteria and pattern check for Monitor Port M0/M1 in the Port Config
–
Monitor Port screen. There are two ways to access Port Config
– Monitor Port
:
Accessing Port Config
– Monitor Port

Click Monitor Port M0/M1 located on Config
in the Menu Bar .

Click the Monitor Port M0/M1 button located
on Quick Launch Buttons .
Port Config
– Monitor Port M0/M1
The Monitor Port setting page allows you to set the headers that you would like to add to packets
transmitted from Monitor Port M0/M1 . NuSet-MiniTAP supports headers including DA/SA , Time Stamp ,
VLAN TAG , IP Header , UDP Header , and IP Fragment . These headers are corresponding with the value
inputting field down below the Monitor Port setting page as show in the table here:

DA/SA: Destination/Source MAC Address.

Time Stamp: N/A. However, a timestamp
header will be added to the packets.

VLAN TAG: VID (VLAN ID).

IP Header: DIP (Destination IP Address) and
SIP (Source IP Address).

UDP Header: DPort (Destination Port) and
SPort (Source Port).

IP Fragment: MTU (Maximum Transmission
Unit)
Button
Apply: Apply and save the changes you
’ve made on this page. After making any settings
on this page, you must click the Apply button or all changes will be lost.