Cutting the grass near tree, block, brick, or stone
Hold and tilt the grass trimmer at a height where the spool does not touch the ground. Cut
the grass using the nylon cord tip like knocking the ground.
NOTICE: When cutting the grass, move the grass trimmer around the tree or blocks so that
the nylon cord does not touch the tree or blocks. It is recommended to keep the tool more
than 5 cm away from the tree or block. If the nylon cord touch the tree or block, the nylon
cord may be torn rapidly. If the nylon cord is torn in the spool, set the nylon cord again
referring to the replacement procedure in this manual.
Using the grass trimmer as an edger
A idler wheel is also provided for easy and better operation while using the grass trimmer
as an edger.
Using the grass trimmer as an edger is suitable for cutting the grass growing along the
bricks or blocks. Adjust the vertical and horizontal angle of the pivoting head.
As shown in the figure, use the idler wheel to move the grass trimmer to cut the grass. You
can cut the grass efficiently by walking in parallel along the bricks or blocks.
MAINTENANCE
WARNING: Always be sure that the tool is switched off and battery cartridge is removed
before attempting to perform inspection or main- tenance on the tool. Failure to switch off
and remove the battery cartridge may result in serious personal injury from accidental
start-up.
NOTICE: Never use gasoline, benzine, thinner, alcohol or the like. Discoloration,
deformation or cracks may result.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by company XTline.
Summary of Contents for XT102910
Page 18: ......
