16
www.XSscuba.com
XS Scuba MultiMax Breathable Inflator Service Manual
NOTE: When threading the valve housing (35) on
to the valve assembly tool, if the square portion of the
stem (32) does not align with the square hole in the
valve insert (36), it will unseat the valve insert (36).
If this happens, remover the valve insert (36), rotate
the stem (32) with a small pair of pliers so that the
square portion of the stem (32), is parallel with the slot
of the valve housing (35). See image below.
Now you can add the white valve insert (36). Make
sure that it is seated all the way down on to the valve
housing (35).
g. Install the lever (37).
i. The lever (37) MUST be oriented opposite
the oval hole.
CAUTION: When installing the lever (37), it must
be oriented opposite the oval outlet hole.
h. Place washer (38) over the threads.
i. Thread nyloc nut (19) on to the threaded shaft.
