English
Using the fan
DX100BR / DX100BS Only
• Operate the fan using the on/off switch (not
supplied). Repeat to switch off.
DX100BTR / DX100BTS Only
• Operate the fan using an on/off switch (not
supplied). Note – the fan may take up to 10
seconds to turn on once the switch has been
operated. When the switch is turned off,
the fan continues to operate for the set time
delay. To adjust the over-run period, turn the
control “T” clockwise to increase and anti-
clockwise to decrease – see Figure D1.
DX100BHTR / DX100BHTS Only
• Automatic mode - The fan automatically
adjusts to slow changes in natural humidity
levels without operating the fan. If the humidity
levels increase at a rate slower than 5% RH
in 5 minutes, up to the pre-set humidity level,
the fan will not be triggered by humidity. This
is to prevent nuisance triggering of the fan. If
humidity levels increase quicker than 5% RH
in 5 minutes the fan will operate. When relative
humidity drops the fan continues to operate for
the adjustable time delay.
• External operation - Use the external on/off
switch. When the fan is switched off, the fan
continues to operate for the adjustable time
delay then goes into automatic mode.
DX100BHPTR / DX100BHPTS Only
• Automatic mode - The fan automatically
adjusts to slow changes in natural humidity
levels without operating the fan. If the humidity
levels increase at a rate slower than 5% RH
in 5 minutes, up to the pre-set humidity level,
the fan will not be triggered by humidity. This
is to prevent nuisance triggering of the fan. If
humidity levels increase quicker than 5% RH
in 5 minutes the fan will operate. When relative
humidity drops the fan continues to operate for
the adjustable time delay.
• External operation - Use the external on/off
switch. When the fan is switched off, the fan
continues to operate for the adjustable time
delay then goes into automatic mode.
• Pull Cord operation – Use the integral pull
cord switch. When the fan is switched off, the
fan continues to operate for the adjustable
time delay then goes into automatic mode.
DX100BPR / DX100BPS Only
• Operate the fan by pulling and releasing the
cord. Repeat to switch off.
All Fans
Re-fit the front cover by hooking in the top first,
and then swing the cover down to clip into place.
Cleaning
(recommended once a month)
1. Before cleaning, isolate the fan completely
from the mains supply.
2. Remove the front cover by depressing the
latch on the underside of the cover and
pulling off the front cover from the bottom.
3. To clean the front cover, either wipe it with
a damp, lint free cloth or wash it with warm
soapy water. Thoroughly dry the front cover
and refit.
4. Do not immerse the fan in water or other
liquids to clean any other parts of the fan.
5. Do not use strong detergents, solvents or
chemical cleaners
6. Allow fan to dry thoroughly before use.
7. Apart from cleaning, no other maintenance is
required.
Disposal
This product should not be disposed
of with household waste.
Please recycle where facilities exist.
Check with your local authority for
recycling advice.
Guarantee
UK only
We, Redring Xpelair Group Limited, provide a
guarantee against faulty parts and manufacture
for a period of 2 years from the date of
purchase. In the unlikely event of a product
breakdown during the guarantee period the
product should be returned to the place of
purchase or to Redring Xpelair Group Limited.
Exclusions
• This guarantee does not cover compensation
for the loss of the product or consequential
loss of any kind.
• Damage or defects to the product arising from
incorrect installation or lack of maintenance.
• Transportation costs.
This guarantee does not affect your
statutory rights
