•
Autosave Screensaver
-> Does automatically save the project right before the
screensaver is starting. (Replaces the old Backup function. Backups are now always
enabled and a backup is being created on every save into the backup folder (10 iterations)
•
Autoload last project
→ Loads the last saved project on the NerdSEQ startup
automatically
•
Load Settings Backup
-> In the unlikely case of a problem with the EEprom (or you swap
a NerdSEQ) you can load the backup of the settings from the SD Card. Be sure to backup
your SD Card from time to time (works only when Debug is ON)
•
NSA Firmware update
- Opens the
for the expanders
(Nerd Sound Adapter)
•
Debug
- > turn on some debug output (internal use)
•
Soft Reset
-> Resets the NerdSEQ when needed (works only when Debug is ON)
Track Assign Screen
In the track assign screen you can assign the different track types such as CV/Gate, Midi or
Trigger16 to one of the tracks. You can enter the track assign screen from the project screen.
There are 8 rows which show the 8 tracks. The default setting for the first 6 tracks is as a CV/Gate
track. The last 2 are the audio (sample) tracks at default, but these can also be changed to either
Midi or to one of the expanders.
You can change the type of the tracks using
SHIFT+ CURSOR LEFT/RIGHT
. Then you can
choose between the CV/Gate function (Tracks 1..6), NSA1,2,3,4 (and if there are expanders
connected, then it will show the recognized expander on the NSA Channel number) and Midi.
NerdSEQ – a tracker based Eurorack sequencer
Page 89
User Manual Revision V1.26 for Firmware V1.26
12 July 2022
Figure 19: Track Assign Screen
