XONTEL Plus PBX, User Manual

Page: 14 / 118

2.4 Connect PBX to Network
2.4.1
Connect PBX to Network via Network Port
Please connect the XonTel Plus PBX to network according to the network diagrams in Section 2.3 Network
Connection. Connect a PSTN line to the FXO port. Use a mobile phone to dial the number of the FXO port, and then
dial *158# to query the IP address of LAN port after hearing IVR. Modify the IP address of PC to make it at the same
network segment of LAN port of the PBX.
You are also allowed to log in the PBX by using the WAN port, but you need to enable the port first.
2.4.2
Preparations for Login
Modify the IP address of the PC to make it at the same network segment with the XonTel Plus PBX, since the default
IP address of LAN port of the PBX is 192.168.11.1 .
Check the connectivity between the PC and the XonTel Plus. Click Start

Run of PC and enter cmd to execute
‘
ping 192.168.11.1
’ to check whether the IP address of LAN port runs normally.
2.4.3
Login to Web Interface
Open a web browser and enter the IP address of LAN port ( the default IP is 192.168.11.1 ). Then the login GUI will
be displayed.
You also can enter the IP address of WAN port, but it’s required to modify the IP address of PC to make it at the same
network segment with WAN port.
It is suggested that you should modify the username and password for security consideration.
By default, the username is admin , while the password is Xontel . After entering username and password, click Login
to enter into the web interface.
Under some circumstances, login of the Web will be limited
：

For three consecutive login failures, you need to slide to validate your user account;

Failing to log in the Web for ten times consecutively, the IP address of the XonTel Plus device will be put into
the blacklist, and you need to reset a new IP address for the device
；
 Successful login or device restart will wipe out login failure records.