Xo XOGRILL40XLT, Care & Use/Installation Manual

Page: 19 / 48

9
insulated jacket installation
IMPORTANT: Before you build the frame, you must take into account the total weight of the
liner, grill, other appliances, countertop and all other finishing materials.
XO Outdoor cooking appliances operate at very HIGH TEMPERATURES. It is absolutely essential
to install an insulated jacket whenever combustible materials are used in the construction of your
outdoor kitchen. Failure to isolate the cooking appliances within an approved insulated jacket can
result in fire, property damage, personal injury or death. Combustible materials include anything
which will burn, emit smoke, melt or support combustion.
Refer to the table on page 18 for the correct dimensions to nstall the insulated jacket..
Determine the entry point for your gas and electrical connections. Create your 4” x 4” rear or bottom
utility access based on location requirements.
Use a carpenter’s level to ensure the framing is level both side to side and front to back.
NEVER under any circumstances run the gas line or electrical wiring between the grill and the
insulated jacket. All excess electrical wire leads must be pulled out beyond the insulated
jacket. Never attempt to install the transformer between the liner and grill.
LINER INSTALLATION
Position the liner in the frame. No part of the combustible construction can protrude above the top or
beyond the front surface face of the liner. Shim the liner as necessary.
APPLIANCE INSTALLATION - CAUTION HEAVY LIFT
Remove the grates from the grill to reduce its weight and using two people, place the grill into the liner.
The side and rear flanges of the grill are desiged to rest on top of the stainless flanges of the liner
without additional fasteners. The grill must be able to be removed for maintenance and service, do not
grout the grill in place.
FINISHING
If desired the gap, if any, between the liner and the counter may be filled with non-combustible sealant.
• Never install this product into a structure built using combustible materials without an
insulated jacket. Doing so risks Fire, Property Damage, Injury or Death.
Observe and follow ALL set backs and clearances set forth in this manual.
For outdoor installation only - Never install or operate in an enclosed space.
Observe and follow ALL overhead clearances set forth in this manual.
• Installation must conform with local codes or, in the absence of local codes, with either the
National Fuel Gas Code, ANSI Z223.1/NFPA 54, Natural Gas and propane Installation Code,
CSA B149.1, or Propane Storage and Handling Code, B149.2, in Canada.
WARNING