XIT 404’s VIDEO PENTAMIRROR - LIGHT AND MOTION
HD MONITOR BACK VERSION 2 MOUNTING INSTRUCTIONS
PENTAMIRROR
MOUNTING BRACKET
www.xit404.com
Revsion 2.0 - JUL2013
Thank you for purchasing Xit 404’s PentaMirror for your Light and Motion Bluefin
Monitor Back Version 2 housing. Below are instructions to help you install your
PentaMirror. On the back are warrranty and instructions to help you prolong the
life of this product.
Assembly Instructions for Light and Motion Monitor Back Version 2 PentaMirror
1. First you will need to attach the PentaMirror mounting bracket onto the back of your
housing. If you currently have a rubber sunshade the Pentamirror mounting bracket
replaces this. Hook the mounting bracket into the slot on top of the display and rotate
the mounting bracket until it seats against the two threaded bosses. Secure the
mounting bracket with the two screws provided. We recommend you apply a small
amount of corrosion inhibitor (such as Lanapro or Lanacote not provided) to these
threads before you screw them into your housing.
2. Once the mounting bracket is secured onto your housing attaching the Pentamirror is
done by hooking the PentaMirror over the mounting bracket and then, while lightly
pressing down, pushing the Pentamirror onto the mounting bracket. It will snap onto
the mounting bracket and in front of the live view display.
3. We recommend that the PentaMirror be tethered to the mounting bracket in case
it pops off. A red Tether is provided for this purpose.
4. Slip either end of the tether thru one of the loops on the Pentamirror. Secure it
by pulling the nib thru one of the holes in the tether until it pops thru. Now attach
the other end to the mounting bracket in the same way.
Disassembling a PentaMirror
1. The PentaMirror will pull off the mounting bracket with a little tug. Grab the box
and pull out until it pops off the mounting bracket.
2. If you want to completely remove the PentaMirror untie the tether from your
mounting bracket.
3. You can leave the mounting bracket attached to your housing
Replacing Mirrors (Image on Back)
1. Inside of the PentaMirror are two hooks that retain the back cover. You need to
remove this cover to replace the mirrors.
2. Using a small screwdriver or even your fingernail pry each hook just enough so it
pushes out. Be careful to not over bend these hooks. Once the hooks are released
pull the cover off.
3. Once the cover is removed the mirrors will drop out.
4. One spare set of mirrors was provided with your kit. Remove the protective plastic
cover and slide the new mirrors into the slots in the box. Be sure the mirrored side
is towards the inside of the box.
5. Now align the cover with the box and push it in until the hooks snap in place.
LMI HD MONITOR
BACK VERSION 2
PENTAMIRROR
RED AQUA PENCIL TETHER
LIGHT AND MOTION BLUEFIN
WITH MONITOR BACK V2
PENTAMIRROR ATTACHED
HOOK PENTAMIRROR
ONTO SLOT IN BRACKET
AND ROTATE DOWN
#4 X 3/8
SCREW
(2)
LIGHT AND MOTION BLUEFIN
WITH MONITOR BACK V2
HOOK TOP OF
BRACKET ONTO
GROOVE IN
MONITOR BACK.
THEN ROTATE
DOWN AND
SECURE WITH
TWO SCREWS
HEX KEY
5/32
PRODUCT CODE: PV0004LM
