XIT 404’s SLR PENTAMIRROR - SUBAL 5D2 HOUSING
INSTALLATION AND MOUNTING INSTRUCTIONS
VIEWFINDER PLUG
BLACK DELRIN
VIEWFINDER
PLUG, SEALING
O-RINGS
INSTALLED
SUBAL 5D2
HOUSING BACK
WITH ITS VIEWFINDER
REMOVED
www.xit404.com
Revsion 2.0 - JUL2013
SEALING O-RINGS
(SUPPLIED INSTALLED)
SUBAL’S
VIEWFINDER
RETAINING
CLIP
Thank you for purchasing Xit 404’s PentaMirror for your Subal 5D2 housing. Below
are instructions to help you prolong the life of this product. Warrenty and some
more pictures to help you install the PentaMirror to your housing are on the back.
Instruction for assembling an SLR type PentaMirror
1. First you will need to replace the Viewfinder on your housing with the Viewfinder
Plug provided with your PentaMirror. Locate the instructions that came with the
plug and follow them to install it.
2. Once the plug is installed into your housing attaching the Pentamirror is done by
hooking the round pocket in the PentaMirror over the plug. Then, while lightly
pressing down, push the Pentamirror onto the plug. It will snap onto the plug and
will be in front of the live view display.
3. We recommend that the PentaMirror be tethered to your housing in case it pops
off the plug. A Red Tether is provided for this purpose.
4. Slip either end of the tether thru one of the loops on the Pentamirror. Secure it by
pulling the tip thru one of the holes in the tether until it pops thru. Now attach the
other end to your housing – you may need to add a split ring, tie wrap, or other
loop sufficient to tie the tether to.
Disassembling a PentaMirror
1. The PentaMirror will pull off the plug with a little tug. Grab the box and pull up
until it pops off the plug.
2. If you want to completely remove the PentaMirror untie the tether from your
housing.
Replacing Mirrors
1. Inside of the PentaMirror are two hooks that retain the back cover. You need to
remove this cover to replace the mirrors.
2. Using a small screwdriver or even your fingernail pry each hook just enough so
it pushes out. Once the hooks are released pull the cover off.
3. Once the cover is removed the mirrors will drop out.
4. One spare set of mirrors was provided with your kit. Remove the protective
plastic cover on the mirrored side and slide the new mirrors into the slots in the
box. Be sure the mirrored side is towards the inside of the box.
5. Now align the cover with the box and push it in until the hooks snap in place
holding the cover on.
PRODUCT CODE: PS0003SU
BOX
MIRRORED
SURFACES
TOWARDS
INSIDE OF BOX
COVER
MIRRORS
