Jul-21, V1.1
Page
13
/
20
DEVICES
DEVICES
Insert parts
Use the provided protective gear (safety glasses and protective
gloves) when inserting parts, to avoid scalding and skin
irritation. Switch the heating/stirring rod off, open the lid and
insert the parts carefully into the solution bath. Use the
provided pliers for insertion.
Close the lid after inserting the parts, and switch the
heating/stirring rod on again.
Tip: To accelerate the dissolving process, you can
mechanically remove support material that is easy to
remove before insertion. When doing so, make sure
that you do not damage delicate areas of the print
object.
Caution: When removing parts of the support structure
mechanically, always wear the provided tight-fitting
safety glasses. Splintering parts of the support
structure can damage eyes or lead to cuts. Make sure
to wear suitable protective gloves. Do NOT use the
provided protective gloves, since these do not provide
mechanical protection.
Caution: The maximum fill level of 10 L must not be
exceeded even after inserting the parts.
Remove parts
The printed parts can be removed during operation.
Caution: If you remove printed parts during operation,
you must wear the provided protective gear (safety
glasses and protective gloves). The starter kit comes
with a set of pliers for easy removal. Before opening the
lid you need to switch off the heating/stirring rod.
The time needed to fully dissolve the support structure of a
printed object strongly depends on the geometry of the part,
