9
a certain time.
This start-up time can be shortened by striking the chisel in the power tool
against the floor one time.
Indicator LEDS
The green power-ON indicator LED lights up when the tool is plugged. If indicator led does not
light up, the mains cord or the controller may be detective. The red service indicator LED lights
up when the carbon brushes are worn out to indicate that the tool needs servicing.
Mounting tool bits
Warning: before do it, make sure unplug the machine!
Chisels come with or without collars.
Figure 1 shows installation of a chisel without a collar (the included
chisel is without a collar). Figure 5
shows installation of a chisel with a collar
Note:
If the Chisel doesn't slide in easily, apply grease to the loading end of the Chisel.
1.
Pull the lock lever to the side, just far
enough to allow the Clisel to be inserted, as
shown in Figure 1.
Figure 1
Note: Flat Notch on Collar-less Chisel must
face the Lock lever.
2.
Insert Chisel with the Flat Notch facing the Lock
Lever, as shown in Figure 2.
Figure 2
3. Slide the Chisel in as far as it will go.
4. Pull the Lock Lever back until it locks the Chisel into
place. See figure 3.
Note: Lock Lever will not lie flat against the chuck.
Figure 3
5. When to Chisel is installed, there will be
approximately 1-3/4'' of play along the Flat Notch of
