xiQ - Technical Manual Version 1.35
31
3.5.4.4.
Drawings board level
figure 3-20, dimensional drawing MQ013xG-ON-BRD
3.5.4.5.
Camera orientation
Please note that the camera orientation of the MQ013xG-ON models are different. The USB 3.0 connector is at the upper side of
the camera. Please see the next figure:
Figure 3-21, MQ013xG-ON, camera orientation
3.5.4.6.
Referenced documents
Onsemi Datasheet PYTHON1300-datasheet-Rev. 2 (June 2016)
3.5.4.7.
Sensor features
feature
Note
Binning
Not implemented
Skipping
Yes, 2x2 skipping supported
ROI
1 ROI with free parameters supported
(x coordinates multiple of 16, y coordinates multiple of 2)
HW Trigger
Trigger with overlap usable (see
4.3.2.2 Triggered mode with overlap
HDR
Knee point based HDR (beta stage), see
4.5.7 HDR – Not implemented, yet
table 3-15, sensor features available
NOTE
The saturation behavior of the PYTHON image sensors can be impacted during integration times longer than approximately 10ms.
A fully exposed pixel may not result in a fully-saturated digital signal, and a fixed row-to-row pattern may be observed in the
captured image.
These effects can typically be mitigated by increasing the analog gain (API function XI_PRM_GAIN) of the image sensor 2.3 dB at
exposure time of 100ms, which re-maps the linear portion of the pixel’s analog signal to the full range of the ADC input to recover
the full digital output range of the device. For some sensors this procedure might not be needed or the required gain is lower than
2.3dB.
It is emphasized that this behavior is within spec of the sensor manufacturer and all published specs.
PN: MQ013MG-ON
13200250
Isol ated I/O 24V 20mA max.
For use with XIMEAapproved connection cables onl
y.
5V
(<1.5W)
Based on the USB-IF ’
s USB 3.0 specific
ation.
USB 3.0 SuperSpeed
M
ad
e i
n E
U
STATUS 1
STATUS 2
POWER
INPUT
