Xilinx VC709, User Manual

Page: 9 / 100

VC709 Evaluation Board www.xilinx.com 9
UG887 (v1.2.1) March 11, 2014
Feature Descriptions
Virtex-7 XC7VX690T-2FFG1761C FPGA
[ Figure 1-2 , callout 1 ]
The VC709 board is populated with the Virtex-7 XC7VX690T-2FFG1761C FPGA.
For further information on Virtex-7 FPGAs, see 7 Series FPGAs Overview (DS180) [Ref 1] .
FPGA Configuration
The VC709 board supports two of the five 7 series FPGA configuration modes:
• Master BPI using the onboard linear BPI flash memory
11 P1 PCI Express connector 8-lane card edge connector 35
12 P2–P5 4 X SFP/SFP+ module connector (I²C 0x50) Molex 74441-0010 31–35
13
U44, J17
USB-to-UART bridge with mini-B USB
connector
Silicon Labs CP2103GM 6
14 U52 I
2
C bus switch (I²C 0x74) (back side of board) TI PCA9548ARGER 29
15 U14 I
2
C bus switch (I²C 0x75) (back side of board) TI PCA9546ARGVR 29
16 DS2–DS9 User LEDs, Green Lumex SML-LX0603GW 25
17 SW3–SW7 User pushbuttons, active-High E-Switch TL3301EP100QG 25
18 SW2 User DIP switch, active-High 8-pole C and K SDA08H1SBD 25
19 SW8, SW9 CPU RESET, FPGA PROG pushbuttons E-Switch TL3301EP100QG 25, 7
20
SW11
Configuration mode/upper linear flash
address DIP switch
5-pole C and K SDA05H1IBD 7
21 SW12 Power on/off slide switch C and K 1201M2S3AQE2 46
22 J35 FMC HPC connector Samtec ASP_134486_01 18–21
23 J19 Xilinx XADC header 2 x 10 0.1-inch male header 27
24 DS1 INIT LED, dual color Red/Green Avago HSMF-C155 38
25 DS10, DS14,
DS16–DS18
Power ON and Power GOOD LEDs Lumex SML-LX0603GW 38
26
Various
Power management system (front and back
side of board) TI UCD9248PFC in conjunction
with various regulators
45–56
27
U13
Memory clock, 233.33 MHz, LVDS (back side
of board) SiTime
SIT9122AC-2D3-25E233.333333
3
28 J35 2 x 5 shrouded PMBus connector Assman HW10G-0202 46
29 J18 12V power input 2 x 3 connector Molex 39-30-1060 46
Table 1-1: VC709 Board Component Descriptions (Cont’d)
Callout
Reference
Designator
Component Description Notes
Schematic
0381499
Page
Number