Xilinx FMC XM104, User Manual, Page: 8 / 21

8 www.xilinx.com FMC XM104 Connectivity Card User Guide
UG536 (v1.1) September 24, 2010
Chapter 1: XM104
Software
Example designs that use this hardware are not provided at this time.
Package Contents
The following items are included in the XM104 shipment:
• XM104 card
• Four (4) mounting screws
• Two (2) standoffs
• Four (4) SMA-P to SMA-P cables
• Serial ATA loopback cable
• Serial ATA cable
• Welcome letter
Necessary Equipment
• Small Phillips screwdriver to secure the XM104 to the board
• PC with Internet access to download documentation, board files, and schematics
System Setup
Complete the following steps to install the XM104 to a Xilinx board. For additional
information on Xilinx boards, refer to the board’s user guide. See
Additional
Documentation, page 5 .
1. Turn off the DC power switch and disconnect the input power source from the board.
2. Remove the XM104 from the electrostatic device (ESD) bag.
3. Using a small Phillips screwdriver, remove the two screws from the bottom side of the
two standoffs on the XM104. These screws will be used to attach the board to the
standoffs attached to the XM104.
4. Install the XM104 to the ML605 FMC HPC connector J64. The XM104 hangs off the
edge of the board as shown in
Figure 1-1, page 9 .
5. Turn the attached board and XM104 such that the FPGA is facing the table. Install two
screws from the bottom side of board's FMC mounting holes into the two standoffs
attached to the XM104. Hand tighten the two mounting screws to the bottom of the
board.
6. Turn the attached board and XM104 unit over such that the Xilinx FPGA is visible.
7. Connect the input power source to the board. Turn the board power input switch to
ON.
The system is now ready for use.