where <interface> is the first interface on the card (see
). For
example:
# ethtool enp1s0f2
Settings for enp1s0f2:
...
Speed:
10000Mb/s
...
Link detected:
yes
2. Confirm that:
• a link is detected
• the reported speed is correct for your network.
3. Examine the network driver information for the interface:
# ethtool -i <interface>
where <interface> is the first interface on the card. For example:
# ethtool -i enp1s0f2
driver:
xilinx_efct
version:
<version number>
...
4. Confirm that:
• the xilinx_efct network driver is shown
• its version is as expected.
Note: The actual version number might differ from the previous example.
Running ip
If you have installed the X3522 low latency network adapter:
1. Use the ip command to list addresses:
$ ip address show
2. Find:
• The first interface on the card (see
).
• Any other interfaces on the card, that can be identified by their adjacent MAC addresses.
Chapter 4: Card Bring-Up and Validation
UG1522 (v1.0) October 18, 2022
Alveo X3522 Installation Guide
29