Xilinx Alveo U55C, Installation Manual

Page: 21 / 27

In the following example output, the
Platform
(xilinx_u55c_gen3x16_xdma_base_2) and
SC
version
(7.1.14) displayed under
Flashable partitions running on FPGA
and
Flashable partitions installed in system
both match.
-----------------------------------------------------
1/1 [0000:5e:00.0] : xilinx_u55c_gen3x16_xdma_base_2
-----------------------------------------------------
Flash properties
Type : spi
Serial Number : XFL1GKKP3E2D
Device properties
Type : u55c
Name : ALVEO U55C
Config Mode : 7
Max Power : 225W
Flashable partitions running on FPGA
Platform : xilinx_u55c_gen3x16_xdma_base_2
SC Version : 7.1.14
Platform UUID : FCC68C40-94CC-3A1E-9A6C-A76BCA494718
Interface UUID : 738F93F1-1FCF-2AAB-F1AF-DFEB9C8992C7
Flashable partitions installed in system
Platform : xilinx_u55c_gen3x16_xdma_base_2
SC Version : 7.1.14
Platform UUID : FCC68C40-94CC-3A1E-9A6C-A76BCA494718
Card Validation
Card installation can be validated using the
xbutil validate
command. This command
performs various tests and checks on the card including PCIe link status, SC version status,
memory and bandwidth tests and auxiliary power connection where applicable. Full command
details can be found in
xbutil documentation. Depending on the card tested, not all tests are valid
or may require the function to be enabled (i.e., Peer-2-Peer).
Use the following command to run the card validation test:
$ /opt/xilinx/xrt/bin/xbutil validate --device <user BDF>
where user BDF is the card to be validated. See Displaying Card BDF Values to obtain the user
BDF value.
Chapter 5: Card Bring-Up and Validation
UG1468 (v1.0) November 23, 2021 www.xilinx.com
Alveo U55C Data Center Accelerator Card Installation Guide 21
Send Feedback