Safety
Xerox
®
WorkCentre
®
4265 Multifunction Printer
13
User Guide
Power Cord
•
Use the power cord supplied with your printer.
•
Plug the power cord directly into a properly grounded electrical outlet. Ensure that each end of the
cord is connected securely. If you do not know if an outlet is grounded, ask an electrician to check
the outlet.
•
Do not use a ground adapter plug to connect the printer to an electrical outlet that does not have a
ground connection terminal.
WARNING:
Avoid the potential of electrical shock by ensuring that the printer is grounded properly.
Electrical products can be hazardous if misused.
•
Verify that the printer is plugged into an outlet that is providing the correct voltage and power.
Review the electrical specification of the printer with an electrician if necessary.
•
Do not place the printer in an area where people can step on the power cord.
•
Do not place objects on the power cord.
•
If the power cord becomes frayed or worn, replace it.
•
Do not plug or unplug the power cord while the power switch is in the On position.
•
To avoid electrical shock and damage to the cord, grasp the plug when unplugging the power cord.
•
Ensure that the electrical outlet is near the printer and is easily accessible.
The power cord is attached to the printer as a plug-in device on the back of the printer. If it is necessary
to disconnect all electrical power from the printer, disconnect the power cord from the electrical outlet.
Emergency Turn Off
If any of the following conditions occur, turn off the printer immediately and disconnect the power cord
from the electrical outlet. Contact an authorized Xerox service representative to correct the problem if:
•
The equipment emits unusual odors or makes unusual noises.
•
The power cable is damaged or frayed.
•
A wall panel circuit breaker, fuse, or other safety device has been tripped.
•
Liquid is spilled into the printer.
•
The printer is exposed to water.
•
Any part of the printer is damaged.
Laser Safety
This printer complies with laser product performance standards set by governmental, national, and
international agencies and is certified as a Class 1 Laser Product. The printer does not emit hazardous
light because the beam is totally enclosed during all modes of customer operation and maintenance.
WARNING:
Use of controls, adjustments, or performance of procedures other than those specified in
this manual can result in hazardous radiation exposure.
