Xerox Wide Format 6705 System, User Manual

Page: 328 / 363

9
System Settings
9.8 Print Service Settings
328
HPGL - Draw Dotted Line
Allows you to set the drawing method for dotted lines.
Select [NORMAL] or [EXTEND]. The factory default is [NORMAL].
Label Offset
Allows you to set the drawing position for the label, by the X- and Y-direction distances from the corner of the media.
Select from [0] to [100(mm)]. The factory defaults for X and Y are [5] and [3], respectively.
Draw Position of Alignment Mark
Allows you to specify the offset and overlap for the allocation mark drawing position.
Select the offset from [0] to [100(mm)], and the overlap from [0] to [400(mm)]. The factory defaults for offset and
overlap are [3] and [0], respectively.
Detect Long Edge
Allows you to set the machine to determine the long edge of originals.
Select [On] or [Off]. The factory default is [Off].
Detect Long Edge - A0 to A4
Allows you to select the allowance range for the long edge size of the input data for each standard size.
In normal use, this is configured as follows: A0 -> A1, A1 -> A2, A2 -> A3, A3 -> A4, A4 -> A4.
Dither Pattern
Allows you to select the combination of dither pattern and density.
Select from [Pattern 1 (Light/Normal/Dark)], [Pattern 2 (Light/Normal/Dark)], and [Pattern 3 (Light/Normal/Dark)].
The factory default is [Pattern 1 (Normal)].
Draw Solid Thin Line
Set whether to draw lines that are thinner than the specified line width as black solid lines without dithering.
Select [Off] or [On (1-511 pixel)]. The factory default is [Off].