3. After each semi-automatic setup routine, to perform the next setup routine, click
Accept and
Next
.
Note:
It is important to remember that these setup routines and all of the other print
engine adjustments are performed only if needed. If the PredictPrint Cloud Server
Intelligence determines that they are not needed, the PredictPrint Stock Wizard skips them.
4. At any time during the process, to cancel the stock setup routines, click
Cancel Setup
.
5. To go to the previous setup, click
Go Back
.
Calibration and Profiling
Color Calibration and Profiling is a fully automated process within the Stock Wizard. The Stock Wizard
passes the stock information to the Fiery Print Server. Calibration and Profiling is not performed with
the other automatic setup routines. This automatic setup routine is performed always after the semi-
automatic adjustments and before any manual adjustments.
The need for calibration and profiling is not determined by the PredictPrint Cloud Server, but by the
Fiery Print Server. The need for calibration is time-based. If more than 7 days pass after the last
calibration, the Stock Wizard performs a calibration check. For profiling, each stock is profiled on the
first setup routine only.
When the calibration and profiling is done through the PredictPrint Stock Wizard, the process uses Full
Width Array and requires 60 pages. If needed, you can perform additional calibration or profiling
outside of the Stock Wizard using the handheld Spectrophotometer on the Fiery Print Server.
You can change the default 7-day time setting for calibration, which is set on the print server. On the
Fiery Print Server Device Center, click
General > Tools > Calibrator
, then click the small gear icon at
the bottom of the page. The Calibration Notification window opens, where you can set the time limit
for the next calibration check.
Calibration and Profiling proceeds as follows:
1. On the Advanced screen, after the semi-automatic setup routines are complete, the Stock Wizard
starts the Calibration and Profiling process automatically.
Note:
If there are no semi-automatic setup routines to perform, the Calibration and
Profiling process is done on the Setup screen.
2. The PredictPrint Stock Wizard coordinates with the Fiery Print Server. The Color Profiling and
Calibration Check is done automatically, and the progress appears on the Fiery Color Xpress
window.
3. To cancel the Calibration and Profiling process, on the Fiery Color Xpress window, click
Cancel
.
4. When the Calibration and Profiling process is complete, a
Success
message appears and the
Fiery Color Xpress window closes automatically.
5. After the Calibration and Profiling process completes, the Done screen appears.
84
